How to Choose Steel for Blow Molds? Meto Explains the Balance Between Wear Resistance and Corrosion Resistance

Contact Meto today to discuss your blow mold steel requirements. Tell us your plastic material and target production volume. We will provide a steel recommendation and mold quotation.

Conformal Cooling in Blow Molds: How Meto Reduces Blow Molding Cycle Time by 20%

Contact Meto today to discuss conformal cooling for your blow mold application. Send your bottle specifications. We will provide a cooling simulation and cycle time estimate.

Heavy Parting Line on Blow Molded Bottles? Meto Shows You How to Find the Root Cause in Mold Structure

Contact Meto today to discuss your blow mold challenges. Send us photos of your defective bottles. We will diagnose the structural cause and provide a solution.

Stainless Steel vs Tool Steel: Meto Tells You Which One to Use for Preform Molds

Contact Meto today to discuss your preform mold steel requirements. Tell us your material and production volume. We will recommend the right steel for your application.

Cold Half Mold vs Hot Half Mold: How to Choose Between Meto's Two Preform Mold Solutions

Contact Meto today to discuss your preform mold requirements. Tell us your annual volume and color change frequency. We will recommend the optimal runner system and provide a quotation.

32 Cavity vs 48 Cavity vs 64 Cavity: Meto Helps You Choose the Right Cap Mold Cavitation

Contact Meto today to discuss your cap mold requirements. Tell us your annual volume and machine specifications. We will recommend the optimal cavitation and provide a quotation.

Preform Yellowing or IV Drop? Meto Teaches You How to Diagnose Mold vs. Process Issues

Contact Meto today for a degradation diagnosis. Send photos of your preforms and your process data. We will help you identify the root cause and provide solutions.

Mold Rust, Corrosion, Pitting? Meto Steel Selection for rPET Materials

Contact Meto today to discuss your rPET mold requirements. Send your material specifications and production volume. We will provide a steel recommendation and quotation.

Blow Mold Bottle Bottom Too Thick? Meto Shows You How to Adjust Preform and Blow Mold Matching

Contact Meto today for a wall thickness analysis. Send your bottle and preform specifications. We will provide recommendations to reduce bottom thickness and lower bottle weight.

The Last Chance Before Mold Scrap: How Much Life Can Meto Refurbishment Extend?

Contact Meto today for a mold assessment. Send photos and specifications. We will provide a refurbishment recommendation and cost estimate. Do not scrap a mold that has life remaining.